R2-1

Paper CraftDownload

R2-1

注意Please pay special attention when you handle a cutter knife and a sharp instrument.

Regarding all our papercraft contained herein, they are prohibited to reproduce and use for other purposes of profit-making without our permission.

Making proceduresR2-1

  • 1

    Download the file and print it out on an optional paper.

  • 2

    Carefully cut an outward form off by a knife, etc.

  • 3

    Lightly trace the bend portion by a thing with a sharp point and crease. If you would trace the paper strongly, the paper would be torn.

  • 4

    If you would paint with a close color to the cutting end of each part by a colored pencil, the stuck parts will not be noticeable.

  • 5

    Assemble the steel wheel and the part.
    • As the adhesive parts of a mirror and a pipe are very small, be careful so as not to tear.

  • 6

    Assemble the each part and glue every part which has the same symbol.
    Assemble the body.
    • Glue the parts “relating to a driver’s seat” to “the body”.
    • Glue the parts for “underneath of the seat” at right and left, and install “the seat”.

  • 7

    Assembling and glue of the rear frame.
    • Assemble the rear frame.
    • Making sure the position of putting the steel wheel in, glue “a fender for rear wheel”.

  • 8

    Making sure the position of glue the front wheel, adhere“a fender for front wheel” to “the body”.

  • 9

    Unify “the body” and “the rear frame” at “the connecting part” and then glue the front steel wheel and after that put the rear wheel into “the rear frame”.

  • 10

    Adhere“a mirror beside a driver’s seat”,“pipe” behind the seat and “a roof” for completion.
    The completion photo